Oneida Dust Deputy Review

Ridgid WD1450 and Oneida Dust Deputy

Ridgid WD1450 and Dust Deputy

Oneida Dust Deputy Review. As mentioned in my previous post on the Home Depot  Ridgid 14 gallon shop vac, it is great except for the filter clogging rapidly. I needed a way to pre-filter the air. I decide upon hooking up an Oneida Dust Deputy to my Ridgid Wet/Dry Vacuum. This dust separator was the solution.

Their are quite a few dust separators on the market, including one that Rockler sells. Kits are also available to make your own. Fortunately, I saw a video by Marc Spagnuolo the   “Wood Whisperer” where he did a comparison of four brands. The Oneida looked like the one for me. I ordered one and it arrived on my doorstep. The Dust Deputy sold on Amazon is basically 2 heavy duty 5 gallon buckets with a cyclone separator on top. The bottom bucket is used if you want to put wheels on it and attach it to your shop vac like I show above. Then you

Oneida Dust Deputy Attached WD1450

Dust Deputy Attached WD1450

slide the top bucket into it. This is for easy removal when you need to empty the dust and chips. Oneida gives you the parts to physically attach it to your vacuum (bolts, foam spacer block, wheels) So it rolls along with your vac. I did not do this right away. Oneida also includes a good quality  hose to hook the cyclone up to the vacuum. If you want to attach it to your vac, cut the foam block to the vacuum’s profile and run the 2 bolts between the bucket and the vac. Yes you have to drill two holes in your vac.

How good does it work? It works great! I emptied my vacuum and attached the Dust Deputy. After vacuuming up a bunch of sawdust and chips, there was just the tiniest bit in the shop vac. Like a teaspoon full if that. Good news for me, I could then install filter bags since they would not fill up quickly. Now the suction remains constantly strong. I move the unit to the power tool I am using, but usually have it hooked up to my table saw. I also use it to clean up the shop.

The unit does build up a static charge. Oneida gives you some copper tabe to attach to the cyclone to dissipate it. You then attach a wire to a washer that drags on the ground to “ground out” the charge. I did get a good jolt one time, though not exactly sure how. Regardless, I am very happy with this product and would buy it again.

Oneida Dust Deputy Dust collection bucket

Dust Deputy Dust collection


Comments

Oneida Dust Deputy Review — 1 Comment

  1. Pingback: Ridgid WD1450 Wet/Dry Vac Review | Made by AlanMade by Alan

Leave a Reply